Here is what I discovered when injecting into balls that have been treated with injections
a) when I inject I make sure the needle tip is inside the testicle as far away from the needle insertion site as possible.
b) after injecting I leave the needle in the testicle for several minutes to give the fluid time to disperse and the built up pressure inside the ball of subside
c) I don't squeeze the testicle during or after injecting
Why?
Adding a fluid into my testicle causes pressure to build up inside the testicle from that fluid.
If the fluid is too
and especially if the needle is removed too soon after injecting, the built up pressure of fluid would squirt out of the needle insertion point. if something benign like saline solution squirts, no big deal.
If something like Everclear squirts out of my ball and into my scrotum, BURN CITY. REALLY REALLY HURTS BIG TIME. SUPER BIG TIME.
On occasion the needle tip, after insertion, would lodge into a spot that was full of scar tissue from previous injections.
When that occurred it was sometimes difficult to inject, other times impossible to inject.
I found that by Rotating the needle tip around and around while it is still inside the ball, and moving it to another location usually positioned it into a location of soft tissue, and then the injection went easily.
I had stopped injecting for a long time.
I have started injecting again recently, about 2ml a week, to see if I can get my balls even smaller and harder.
Doubt that they will ever atrophy into nothing, but if they get even smaller and harder that would make it seem almost like I finally got castrated.
It just seems so unlikely that I will ever be able to get the castration that I would like to get, to finally finish the job, that I am open to more injections just to see what will develop. Will post an occasional update.
These are my experiences; they are not suggestions or recommendations.
I do not advise peopl
relating what I did.
Scrotum damag
SteveA (imported) wrote: Sat Sep 22, 2012 9:58 am
e
Time to stop
SteveA (imported) wrote: Thu May 13, 2010 8:39 am
I have been injecting my balls with
Everclear for about two yrs. Sometimes I inject every week but lately I have discovered a problem. My balls are small and hard. Dead, I think.
But last week I injected about .5 ml in my rt. ball with much pressure on the plunger. A day later I had pain from the scrotum and then the outer layer of skin started flaking off. Apparently the Everclear which I injected into the ball squirted out into the scrotum. Since I am not ready to have
the balls and scrotum cut off. It is time to stop injecting.

warning: Do not dtink the Everclear straight:D