Page 3 of 3

Re: 1st Everclear grain alcohol injection

Posted: Tue Oct 18, 2022 8:02 am
by justapup (imported)
Nathan74 (imported) wrote: Mon Oct 17, 2022 12:07 pm I'm almost certain that after I'm done with this, that I won't have the balls for it either, lol.

Hehehe, that's true.

Re: 1st Everclear grain alcohol injection

Posted: Tue Oct 18, 2022 9:25 am
by erikboy (imported)
I am curious, for how many months you have been on Androcur?

Re: 1st Everclear grain alcohol injection

Posted: Wed Oct 19, 2022 6:18 pm
by Nathan74 (imported)
It's now day 3 after the calcium chloride injections and all that I can say is wow, that was painful. I'm not here to discourage or encourage but if you can get access to a normal orchiectomy, it's much better than this option. Yesterday was the worst and I couldn't help but to think how wonderful it would have been if someone would have taken mercy on me and removed my testicles just so it would stop hurting. I barely ate anything for the first two days because the constant gut pain took away my appetite. I was also really tired and I that all that I could do was take pain medication and rest. Yesterday was so bad that my inflamed balls had swollen up and they wanted to go up into the inguinal canals but they were too big. And every time I got up from a sitting position to stretch my back I could feel the cords pulling hard and it felt awful. Thankfully today when I got up some of the swelling had gone down and the pain was about half as bad. So the worst of it is over but I can tell that I'll be dealing with pain for a couple of weeks.

I still don't have any regrets. My advice is that if you have a physical job give yourself two weeks. A non physical job, one week, but be prepared to be incapacitated for the first 3 days. Another thing worth mentioning is that the damage inflicted by a 3cc injection of 189 proof grain alcohol is nothing compared to the damage caused by a 1cc injection of 30 percent calcium chloride mixed with 189 proof grain alcohol. Now I want to be clear, I didn't mix a 30 percent liquid solution of calcium chloride with Everclear, I mixed 30
Nathan74 (imported) wrote: Sat Oct 15, 2022 9:19 pm grams of calcium chloride powder with
100 ml of Everclear 189 proof grain alcohol. The stuff had the consistency and appearance of slightly watered down semen. It pretty thick and hard to get into and out of the syringe. I was also pulling from the bottom of the beaker where the solution even thicker. I might have gotten more than 30 percent, I don't know? The injections that I did were pretty potent and intended to get the job over with asap.

Re: 1st Everclear grain alcohol injection

Posted: Wed Oct 19, 2022 7:18 pm
by Nathan74 (imported)
erikboy (imported) wrote: Tue Oct 18, 2022 9:25 am I am curious, for how many months you have been on Androcur?

I did it for 6-7 months back in 2019 and then I stopped. My T level was tested at 180 a few months after I stopped and I don't think it went up much higher than that until the beginning of 2021. So I would say that my T production was permanently changed after that first 7 months of usage. I started to get a little bit of a sex drive by the beginning of 2021 so I went back on it at 50 mg per day for another 6-7 months and that pretty much finished them off. When I had my T tested over the summer it was 146 on the first test and 151 on the second that the urologist requested. I had to go on T shots because my body couldn't handle the long-term loss of testosterone.

Re: 1st Everclear grain alcohol injection

Posted: Thu Nov 17, 2022 9:08 pm
by Nathan74 (imported)
ScotsEunuch (imported) wrote: Sat Oct 15, 2022 10:16 am Thanks for the description.

What’s the minimum ABV that’s effective? I’
ScotsEunuch (imported) wrote: Sat Oct 15, 2022 10:16 am m not sure we can buy spirit at 189/190 proof here in the UK? I
’m guessing there’
ScotsEunuch (imported) wrote: Sat Oct 15, 2022 10:16 am s not a huge risk of infection at those alcohol levels but what are the risks from this method?

I would say leakage of the mixture from the testicle and into the scrotum. There are ways to increase the proof through distillation. That's when you heat the alcohol and boil off the alcohol first at a lower temperature while most of the water stays in the vessel. I would do some research, there's a way to pull it off. You want at least 185 proof in my opinion for the best results. But either way, if you add the calcium chloride you can still get good results even at a lower proof. If the proof is lower I would go for a higher concentration of calcium chloride, such as 40 percent. Which came to 40 grams per 100 ml of alcohol if you are using the food grade pellets.

Re: 1st Everclear grain alcohol injection

Posted: Thu Nov 17, 2022 9:27 pm
by Nathan74 (imported)
I'm about 40 days out from a round of 3cc everclear injections, and 30 days out from an everclear CaCl injection of 1cc into each testicle. It's now time for another round of Everclear and CaCl. Hopefully the nerve endings are dead so things are a bit more comfortable this time. My balls have literally no feeling at all and have gotten hard. The cords and connective tissues have shortened and they now stay partially inside me. The right one is a little bigger than the left and hangs lower and is just begging me for the needle. After all the swelling went away my scrotum started to tighten up nicely.

The first 10 days were rough and then the pain went to zero and the swelling took a few more weeks. Since then it's been great, they have shrunk some and my pants and shorts are a lot more comfortable. I can't wait to get them cut out of me and gone. I'm looking forward to jumping on a bicycle and going for a ride with no nuts but I'm going to save that until I'm well healed after surgery. That's my plan for spring time.

Re: 1st Everclear grain alcohol injection

Posted: Fri Nov 18, 2022 1:25 pm
by WheelyCurious
Nathan74 (imported) wrote: Thu Nov 17, 2022 9:08 pm I would say leakage of the mixture from the testicle and into the scrotum. There are ways to increase the proof through distillation. That's when you heat the alcohol and boil off the alcohol first at a lower temperature while most of the water stays in the vessel. I would do some research, there's a way to pull it off. You want at least 185 proof in my opinion for the best results. But either way, if you add the calcium chloride you can still get good results even at a lower proof. If the proof is lower I would go for a higher concentration of calcium chloride, such as 40 percent. Which came to 40 grams per 100 ml of alcohol if you are using the food grade pellets.

Minor note, you can't easily get the % alcohol above about 93% as water and alcohol form an 'aezeotropic' (sp?) mixture that can't be separated by distillation. To get higher percentages requires the use of more complex treatments with chemicals that have an even greater attraction to water, and you DON'T want to put that sort of alcohol into your body as it will destructively pull water out of the surrounding tissues to get back to the aezeotrope... Proof is simply twice the % alcohol, so you can't get more than about 190 proof by distillation...

In terms of killing any bacteria or viruses, anything over about 50% / 100 proof will do. No idea about what the best proof would be for killing balls, but they made mention of it in some of the papers on using CaCl on animals, which are linked early in the CaCl thread...

WheelyCurious