[quote="MadScience (imported)"MadScience (imported) wrote: Mon Aug 27, 2018 5:19 pm Hi there,
The normal dose volume is remarkably consistent at 1.0 to 1.5ml, at a minimum concentration of 20%, though I would recommend 30-50%. Mixing in sterile water works fine, but mixing it in high purity Ethanol (like Everclear) makes it more effective, faster. Using more than 1.5ml per testicle is never a good idea, as it can leak back out. The capsule is fairly impervious and keep the effects nicely confined inside, but tissues of the scrotum outside are not.
Using less than 1.0ml leaves the possibility of not reaching everywhere and completing the job. At that point, switching to Ethanol *might* be an option, but CaCl should never follow anything but previous plain saline. It should be the only thing used, one time. If done right it is a super simple, guaranteed one-injection kill. If you get impatient and inject CaCl after previous Ethanol injections, or a prior CaCl injection - with all of the hardening they do inside - it is very likely to easily leak back out and cause big problems.
On the other hand, if you tie off the ball and keep it vertical, enter from the top towards the front with about a 1" 25ga or thinner needle, you should be able to very slowly (count off 20 seconds or so) inject all of the CaCl solution well into the center and keep it there, letting gravity help you. Keeping a hand towel held
when you withdraw it will wick away any liquid following the needle out, and it's a good idea to make the other end of the towel wet, so you can wet wipe/re-dry the surface before you put a flexible bandage on. Leave it lightly banded like that for a good 20min to keep everything in place. I masturbated gently to distribute the solution around, which worked very well (and I came really hard, probably from the thought of what was happeningMadScience (imported) wrote: Mon Aug 27, 2018 5:19 pm time=1531389240]
against the side of the needle
If I had it to do over again, the only thing I'd change would be to use an ethanol solution, probably 40-50% strength so I could watch the effects go more quickly. It's very, very definite - once that plunger hits bottom, the ball is definitely going to die, it's just a matter of waiting - but I think it would've been even more interesting to watch swell and shrivel and inflate again in different uneven shapes, trying to save itself, but more quickly.
Those are my experience
[/quote]
s and thoughts, I hope they're helpful!
MadScience
MadScience has good advice. I agree that you probably don't need anything like 1.5ml since your balls are small. The 31 ga needle will almost certainly guarantee no leakage, but how long is it? If it's a typical insulin syringe then it might be too short. One inch long is much better.